Anybody building their own PC?
I am a little rusty on the latest tech.
What is a good mother board around $100?
What is a good processor around $100?
I need 3 PCI slots and preferably DDR3 memory.
I plan on using external video.
These are some of the requirements.
http://thread.gmane.org/gmane.linux.distributions.emc.user/11971/focus=11974
Some of the recommendations seem out of date.
Low heat on the processor would be a plus.
Paul Lamar
Paul,
What size chassis? Reason I mention this first is you'll want a box to put it in,
shielded from any shop dust (kills computers way too fast!) and still have the heat
flow out. Air filter (some Fuel Injected cars have nice flat ones with a rubber
gasket to help seal them), protected from coolant over spray, and fans to provide constant
air flow through the box.
Next step is to go to newegg and look at "processor and motherboard combo's"
http://www.newegg.com/Store/ComboDeals.aspx?ComboStoreID=1&name=CPUs-Motherboards
This $219 combo is good:
Intel Core2 Duo E7500 2.93GHz LGA 775 65W Dual-Core - Retail
ASUS P5Q Pro Turbo ATX Intel Motherboard - Retail
You mentioned an "external graphics card" which I take to mean not built into the chipset,
but add in slot.
Add Memory, Hard Drive, and a Case..... about $400 total for a decent system.
For a shop computer, also look at 'lease returns' as you can get a decent deal:
discount electronics is here in Austin. Bascially they buy up the Dell Lease returns,
and resell them. Nothing fancy, but for $200 if it dies (you did back everything up?)
it isn't too bad.
http://www.discountelectronics.com (local in Austin, TX)
I can not keep up with the 'latest/greatest' systems. So the above is courtesy of my 19 year
old son who started asking what games or sims you wanted to run.... then shrugged when I said
$200 for processor + motherboard, hence newegg.
Tom
Six foot high, 19 inch wide standard electronic rack :)
I have one and nobody seems to want it so I am going to use
it for the controller one my NC mill. BTW anybody want
a nine track tape recorder with an RS232 interface that runs
under DOS?
Thanks Tom
Paul lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.