Paul

There is an outfit  just north of me here that does metal spinning and
deep draw forming..he successfully installed a turbine in an Exec 90, he
know his stuff. I'll dig out the old files if you like.
I don't think I described very well what I was thinking.  I could render
something up but do not have the exact dims of the rear housing.. Do you
have a 3D model in Solid Works?    I could more clearly show you my
thoughts.  Used to have a press like that in the bottom picture , made a
lot  of  horseshoes....

jeff


Well sort of. I have a step file that will load into SW.

Here it is. Just unzip it.

-------------------------------------------------------

Jeff, here are some renderings of that alloy end house I sent.

The replaceable sheet metal wear surface is .090 4130 heat treated
to Rockwell 64 and Blanchard ground on one side.

What would it cost to make one of these out of billet.
We could build up an engine and test it.
The real market is one rotors where engine weight is critical.
This should save up to 20 pounds.

Paul Lamar