jeff

 Jeff this step file should import into solid works OK.
 If you have trouble doing this let me know.
 I did not fillet the bottom of the pockets as Rhino does
 not do that well. Just use a 1/2 inch ball mill for the pockets.

 I think the best approach to the spacers is use 1 inch
 round aluminum bar stock and tie them together with
 tig welded 3/16 sheet. Two are counter bored for
 the hollow dowel pins. For a fine touch the sheet can
 be rolled on a 14 inch radius. This, I think, would be the
 lowest cost way. Putting the motor mounts on the plate
 relieves the spacers from the 600 ft pound prop torque.
 The only thing the spacers see is the 200 ft pound engine torque.

 The counter bore on the back side is a per Tray's instruction
 to hold his shaft seal.

 Be a good idea to make one set and see if it fits a
 end housing. If you don't have one I can have Mazdatrix
 ship you a junk end housing.

 The Barry cup holder stp file will follow shortly.

 Paul Lamar


 Paul


this STP.  file did not show up.just gibberish. Maybe try another type.....

jeff

OK Jeff Here is an iges file zipped.

What version of SW are you running Jeff?

Jarrett would you please try to load that stp file in SW.


Paul Lamar