Paul, I don't know if you have this covered in your drawing,
 but there is an oil seal of some kind pressed into the TC PSRU
 base plate. I'm shipping it out today to Jeff.
 C. Smith

 Yes the oil seal counter bore on the back side of the plate is in the
 3D I sent to Jeff.

 Here it is in Tracy's dwg.
 Did you notice a shallow counter bore on the front side?
 I am not sure he is still shipping them this way.

 What is not is the mounting holes for the starter. I found an error
 in Tracy's dwg so I left out the holes. It is easy to match drill
 the holes once you have the 2nd gen starter.

 Jeff, please take some pictures of the final product and send them to
 me.

 I'll put your name in address in the parts for sale section on the web
 site.

 BTW we also need some one inch OD spacers drilled and two of them
 counter bored
 for the hollow dowel pins. That can easily be done on a manual lathe.
 Of course an NC lathe could knock out a bunch at low cost.
 Craig has a set of spacer blocks from Tracy's that are rather crude
 but the correct length can be determined by measuring those.

 Paul Lamar



Paul

I really don't have any 3D of the plate..the cups came in.. Some how we
need to get that here....If I had that cutting will start
today..............
The dowels are 16mm or .6296, how deep you need them bored???.....
jeff

Did that that solid works file from Jarrett not work?

OK It appears to be something wrong with the SLTPRT file extension.
Try these.

I don't have an end housing here with the hollow dowels but over kill won't
hurt. My guess is 3/4 of an inch.

Paul Lamar