Subject: One rotor replacement for O-200
From: Rotary Engine
Date: 9/19/2009, 12:16 PM
To: AAA Put this in the To box


  Paul

  Thanks for taking the time to work on rotary engine conversions for
  aircraft,
  I, like you, believe it is the best engine out there for the job.  I have
  a Wittman Tailwind W8 with an O200.  When the engine needs overhauled Id
  like to have a rotary to go in it.  It seems like the Masda's may be to
  heavy wet for the application,  what are your thoughts?

  Phil Burgess
  W73
  Mid-Atlantic Soaring
  Fairfield PA

  Yes it is too heavy for a direct replacement for the 100 HP O-200 but
  recently
  somebody has joined the news letter that is quite reasonable when it comes
  to
  making NC milled aluminum parts. His name is Jeff Doddridge.

  We have been kicking around a design for a relatively low cost front and
  rear rotor housing made from aluminum which would yield a 125 HP Mazda
 based
  one rotor engine competitive in weight to the 100 HP O-200.

  Here are some 3D's and a picture or two.

  Richard Sohn is also working on an aluminum version of a one rotor Mazda.

  Richard Sohn <res12@fairpoint.net

  Paul Lamar


 Put the full 2 rotor 13b on the Tailwind..  People are putting up to
 O-360's on Tailwinds, with the O-320 being the engine of choice.  My
 impression is that it's relatively easy to build a 13b which matches
 the weight of an O-320..


 Matt-

 If you go that route we have plenty of installation layout dwgs.

 We also have a new asymmetric motor plate allowing a cool side mounted rad.


 Paul Lamar

Paul,

With a fuselage tank, is there any place an aircraft (updraft) carb
could be located to have gravity feed fuel?  I'm thinking light
weight...  How about p-port engine..  Carb mounted on a longish runner
low and aft on the cold side of the engine with a plenum that connects
the p-ports to the runner..


Matt-

Interesting idea Matt.

That should work fine if you have several inches of room over
the engine. You wind up with a rather large plenum but that should
be OK if it is made out of stiff stuff like carbon fiber as the
collapse loads will be high when the throttle is closed.
You will probably need a couple of anti collapse columns
inside it.

Got any cheap used aircraft up draft carbs lying around?

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.