Subject: 3:1 belt drive in an RV7A
From: Rotary Engine
Date: 9/20/2009, 3:40 PM
To: AAA Put this in the To box


Paul    you had mentioned 3-1 belt drive and if weight not more
than Tracey gear drive  I could lower engine - 13B and have more intake
space  and has anyone used and built such drives     If I lowered engine
I would have to move it slightly forward but then could mount large
radiator behind and slight above engine       Are you going to the NM or
AZ rv flyin next month    I am building RV7A

Keith Menard

Ken welter uses belt drives on his Coot.

On an RV7 you don't need any more room on top of the engine.
The intake fits fine.

Behind the engine is not a good place for the rad.

You need to get the air both in and out. You need to push
the engine forward about 10 inches to do that. That gives the needed
space behind the rad to work.  The the cowl must be then
pressurized and the loads on the cowl become enormous. It becomes near
impossible to seal the cowl. 0.1 psi inside the cowl makes it want to
act like a ballon. If the cowl is 48 wide and 40 inches long the
load on the top alone of the cowl becomes 200 pounds. What happens is
the cowl will leak someplace else. Probably out around the exhaust so
you never get the pressure in front of the rad that you really need.

Moving the engine 10 inches forward is not a good idea for a
friendly CG location.

Also the upper belt pulley would have to be about 12 inches in diameter.

All and all a bulky arrangement.

BTW a lot of this is covered in my book. "How to Cool Your Wankel". I
have a special for newsletter readers. Send 30 cash and 5 cash for
mailing and I will  send you one. No checks no money
orders and no credit cards.

830 East Santa Maria St.
Suite 303 <<<< very important
Santa Paula
CA 93060


Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.