Subject: "P" port sealing plates
From: Rotary Engine
Date: 9/22/2009, 8:29 PM
To: AAA Put this in the To box


 Kelly Troyer wrote:
 Paul,
   I would like to buy 2 of your "P" port sealing plates............Please
 let me
 know how much and where to send payment.............

 Thanks,
 --
 Kelly Troyer
 "Dyke Delta"_13B ROTARY Engine
 "RWS"_RD1C/EC2/EM2
 "Mistral"_Backplate/Oil Manifold


 Sure no problem. Every body pays cash. No checks or credit cards.
 Ten dollars each. Plus $5 US PO flate rate box.
 send to:

 Suite 303
 830 East Santa Maria St.
 Santa Paula CA
 93060

 We should have some contoured SS tubes any day now to go along with
 that.

 We also have a whole bunch of other bits and pieces for slide throttle
 p-ports.

 Paul Lamar


 Paul,
 Has anyone pressure tested the sealing plates?  If so, what would be an
 adequate pressure to test them.  I'm figuring 45 psi which is 3 X my
 normal
 operating pressure.

 Mark S.

 I was going to suggest 50 psi.

 Paul Lamar


 Sounds good to me.

 Mark

 The beauty of these sealing plates is they are easily repairable if you do
 have a leak.

 If you are talented with a Dremal tool it is possible to put a large
O-ring
 in there :)

 Paul Lamar


Paul,
As long as the RTV does its job, why install an o-ring, belt and
suspenders?  Where are we talking about putting the o-ring?  How would you
go about replacing the o-ring if it leaked?  I like the RTV solution better
as you can easily re-do it if it leaks.

Mark S.

Just for grins? :)


The O-ring would go in the joint to seal both out and sideways
in theory. It is a compound grove so hard to machine even in an
NC mill.

Paul Lamar

Well, I'll know in a couple of days whether my p-ports pass the 50# pressure
test.

Mark

I have my fingers crossed :)

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.