Subject: "P" port sealing plates O-rings
From: Rotary Engine
Date: 9/23/2009, 6:22 PM
To: AAA Put this in the To box



I was able to get a real fat O-ring in there.
.139 section. This should ease the sealing problem.
I'll be able to retrofit the blocks if people send them to me.
It will increase the price somewhat but I think maybe only $5 additional.

I still have about 35 so perhaps Jeff can machine the groove.

-----------------------------------------------------------

If you want O-ring slots in your sealing blocks mail them back to
me and I will do them free of charge and mail them back to you free of charge.

I'll be doing about 35 so a few more won't hurt.

Also when pressure testing your P-port put a bit of fresh RTV
around the tube inside the water jacket and the 50 psi test
pressure will force that into any leaks you may have at that
point. Use it sparingly as you don't want it floating around
inside the cooling system. It could plug a tube or two in the rad.

Kelly, you will receive your blocks with the O-ring grooves.

Paul Lamar

-

Hi Paul
  I'll drop my sealing blocks in the mail but I was wondering what is
the O-Rings size we should order... Cross section, radius... Or do you
have a part number to make it easy?

Mike C.

The shaft OD is 2 inch so the section size is .139
http://www.mcmaster.com/#o-rings/=3rh0j7

AS568A Dash Number     226

soft Kairez

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.