Subject: "P" port sealing plates O-rings
From: Rotary Engine
Date: 9/24/2009, 10:57 AM
To: AAA Put this in the To box



I was able to get a real fat O-ring in there.
.139 section. This should ease the sealing problem.
I'll be able to retrofit the blocks if people send them to me.
It will increase the price somewhat but I think maybe only $5 additional.

I still have about 35 so perhaps Jeff can machine the groove.

-----------------------------------------------------------

If you want O-ring slots in your sealing blocks mail them back to me and I will do them free of charge and mail them back to you free of charge.

I'll be doing about 35 so a few more won't hurt.

Also when pressure testing your P-port put a bit of fresh RTV around the tube inside the water jacket and the 50 psi test pressure will force that into any leaks you may have at that point. Use it sparingly as you don't want it floating around inside the cooling system. It could plug a tube or two in the rad.

Kelly, you will receive your blocks with the O-ring grooves.

Paul Lamar

-

Hi Paul
   I'll drop my sealing blocks in the mail but I was wondering what is the O-Rings size we should order... Cross section, radius... Or do you have a part number to make it easy?

Mike C.

The shaft OD is 2 inch so the section size is .139
http://www.mcmaster.com/#o-rings/=3rh0j7

AS568A Dash Number     226

soft Kairez

Paul Lamar
---------------------------------------------

Hi Paul,
    Should it be a square or round O-Ring...

The square Info:

Part Number:  4061T248  $7.32 per Pack of 25
AS568A Dash Number   226

Temperature Range   -20° to +225°F


    For the round O-Rings, I could only find "Hard" for "Kalrez" and
they cost ~$160 - $170 each... Looked like the Fluorosilicone was
much more reasonable at $9 for a pack of 2 but the Temp range was
much lower at -75F to +400F as compared to the Kalrez which
was +32F to +600F here is the link:  http://www.mcmaster.com/#o-rings/=3rtpiw
Which one do we need?  I didn't think that the P-Port tube would get
anywhere near +400F especially while running but would see some rise
through heat soaking after shut down.

Mike C.

Really? One can get Teflon encapsulated silicone O-rings from
Creavey for way less than that. Try this outfit. They are over kill
for this application. We use these for the water jacket O-rings
around the rotor housing.

Also try Viton.

True it will never get to 400 F.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.