Subject: Motor plate hole lay out
From: Rotary Engine
Date: 9/26/2009, 3:10 PM
To: AAA Put this in the To box


Paul

I pulled these numbers off the machine..........check over see if it
makes sense.... only a couple of holes seem to be right on.....

The datum for the X is the flat that makes the exhaust and  intake side,
the Y is the oil pan face.....

jeff

OK Jeff I'll take a look at it.

Perhaps a better datum is the center of the e-shaft axis.
I'll see what I can do.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.