Subject: SS P-port-tubes are in.
From: Rotary Engine
Date: 9/30/2009, 4:10 PM
To: AAA Put this in the To box

Larry did a great job. Saves a lot tedious labor contouring the tube to fit
the inner steel rotor housing liner wear surface. To be welded in.

$20 cash each plus $5 shipping.
SS tube is expensive.

830 East Santa Maria St.
Suite #303
Santa Paula CA
93060

Craig, I am shipping your slide throttle kit today.

Paul Lamar


Paul--
    Now that you have the SS P-port tubes in, can they be purchased from
you AND, additionally, installed in conjunction along WITH the P-porting
procedure at the address you listed earlier:

Paul Lamar C/O
Light Speed Engineering
 416 E. Santa Maria Street,
Hangar #15, Santa Paula, CA 93060

Thanks!
Paul Vermillion

Correct Paul. There is always somebody there to receive stuff as I am in
and out of the hanger all the time.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.