Paul Lamar, I have a question.
Does the MAF sensor you chose have a pulse output or an analog voltage
output?
Is the output linear with air mass flow? If not, most of the schemes
discussed here will produce drastic F/A mixture changes if there is any
change in output from the MAF verses the "calibration" adjustment point
(made near full engine load conditions?).
I did some net research on auto type MAF sensors and there is no
standard for output signal format that I can find. Also, I could not
find any info on the accuracy or linearity of the output signal vs
actual air mass flow. If you have a source of information on your
sensor of choice, please post it so we can all become better educated.
"The devil is in the details"
The author of that pithy saying might well have been an engine fuel
system designer ;-)
Thanks
Craig Taylor
It has an analog 0 to 5 volts out put.
Very linear if used with a TLC 555.
I have not calibrated the MAF but it is easy to do holding it out
the window of a moving car :)
We will discover more on the dyno when we can monitor the output as a
function of HP out.
Paul Lamar
Just make sure someone else is driving. It's hard enough for people to
drive using a hands free phone. One of these days I'll catch Paul doing one
of his experiments from his car ;)
Ernesto
Ernesto is local CHP and he has be trying for ten years :)
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.