Paul Lamar, I have a question.
Does the MAF sensor you chose have a pulse output or an analog voltage output?
Is the output linear with air mass flow? If not, most of the schemes discussed here will produce drastic F/A mixture changes
if there is any change in output from the MAF verses the "calibration" adjustment point (made near full engine load conditions?).
I did some net research on auto type MAF sensors and there is no standard for output signal format that I can find. Also, I could not find any info on the accuracy or linearity of the output signal vs actual air mass flow. If you have a source of information on your sensor of choice, please post it so we can all become better educated.
"The devil is in the details"
The author of that pithy saying might well have been an engine fuel system designer ;-)
Thanks
Craig Taylor
It has an analog 0 to 5 volts out put.
Very linear if used with a TLC 555.
I have not calibrated the MAF but it is easy to do holding it out
the window of a moving car :)
We will discover more on the dyno when we can monitor the output as a function of HP out.
Paul
Lamar
-----------------
Paul, do you have a vendor specification sheet on the hot wire MAF
sensor? Or the original vendor name and part number so I can try and find it
myself?
I tried using the stamped information on the picture of the back housing
of the MAF in the 555 injection article, but other than it being a Ford
used part I found no useful info on the net.
Craig T
Here is some stuff on a Ford V8.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.