This is a little off topic, but in order to get my rotary powered plane
into the
air, I need to install an ARC RT359A
transponder, and I need the pin out to do so. Anyone have one or know
where I
can find one?
Thanks,
Brian Trubee
Redmond, Wa
Brian,
I did a quick search and found this. Not sure whether it is correct but
this is
what it lists:
(URL is:
http://newsgroups.derkeiler.com/Archive/Rec/rec.aviation.homebuilt/2006-09/msg00
190.html )
Top row of pins are odd #s 1 to 23 right to left. Bottom row are even
#s 2 to 22 right to left.
PIN
3 Remote IDENT Sw
5 Remote IDENT Sw
9 Switched A+ OUT (+LV)
2 GND
11 MODE C COMMON
14 A1
13 A2
15 A4
19 B1
17 B2
16 B4
21 C1
18 C2
20 C4
10 D4
22 A+ INPUT
12 LIGHTING
1 GND
23 PWR JUMPER
8 PWR JUMPER
For 14 VDC operation, connect pins 8 and 23. For 28 VDC operation,
connect dropping resistor between pins 8 and 23.
Hope this helps
Jack Hilditch
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.