Subject: off topic, need transponder pin out
From: Rotary Engine
Date: 10/6/2009, 8:50 PM
To: AAA Put this in the To box


This is a little off topic, but in order to get my rotary powered plane
into the
air, I need to install an ARC RT359A
transponder, and I need the pin out to do so. Anyone have one or know where
I
can find one?
Thanks,
Brian Trubee
Redmond, Wa

Brian,

I did a quick search and found this.  Not sure whether it is correct but

this is
what it lists:
(URL is:
http://newsgroups.derkeiler.com/Archive/Rec/rec.aviation.homebuilt/2006-
09/msg00
190.html )

Top row of pins are odd #s 1 to 23 right to left. Bottom row are even
#s 2 to 22 right to left.
PIN
3 Remote IDENT Sw
5 Remote IDENT Sw
9 Switched A+ OUT (+LV)
2 GND
11 MODE C COMMON
14 A1
13 A2
15 A4
19 B1
17 B2
16 B4
21 C1
18 C2
20 C4
10 D4
22 A+ INPUT
12 LIGHTING
1 GND
23 PWR JUMPER
8 PWR JUMPER

For 14 VDC operation, connect pins 8 and 23. For 28 VDC operation,
connect dropping resistor between pins 8 and 23.


Hope this helps

Jack Hilditch

Jack's information synch's with my copy of the Quick Shot Avionics
Installation Reference Manual.  If anyone needs an excellent reference
for a variety of installations, I'd suggest obtaining a copy of this
reference manual.

~ Nick Jilek

Brian,

Do yourself a big favor and get a different transponder!  I know, that one
was cheap and it probably has a yellow tag and all.  I went through 4 FOUR
of those F%(* things.  They were all intermittently working (hence reason
they could all pass certification).  Often they reported the wrong code
and/or altitude, used a lot of power and got hot, or just didn't work at
all, and the antenna connector is of dubious quality.

Lets face it, those things are all really old versions or old
technology.  Any one you are likely to find came out of a plane that was
being upgraded because the owner was tired of it not working just when he
needed it.  Before you go to all the trouble of installing it, just get
something else.  There are lots of great solid state options out there for
reasonable money.  You can probably sell the one you have for about what you
paid.

I finally installed the Narco slide in replacement (which still had to be
modified some to get it to fit) but I was still dealing with a loose antenna
connection.  Finally rigged that with zip ties, safety wire, and RTV and it
is Soooo much nicer the have a transponder that I can rely on, is nicely
lit, one touch VFR, and does not blow the 7A circuit breaker all the time.

JMHO

-- David Leonard

Turbo Rotary RV-6 N4VY
http://N4VY.RotaryRoster.net
http://RotaryRoster.net



Thanks for the heads up, Dave. I might try it  for a while and then sell it if it is the piece of crap you say it is. I'm going to install it in such a way that it is easy to remove and non- permanent.

Brian Trubee


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.