Subject: 555 fuel injection- nonlinear MAF sensor
From: Rotary Engine
Date: 10/7/2009, 2:15 PM
To: AAA Put this in the To box


 Note on the pdf document showing the thermal MAF sensor output.

 The sensor output voltage vs actual mass air flow is nonlinear and not a
 simple function.  It as a complex polynomial and can only be reasonably
 dealt with by a lookup table using a uC as the controller.

  This effectively makes a simple analog-555 approach impossible.
 Craig Taylor


 Unfortunately I have to agree but we have come up with a custom $5 555 that
 solves the problem. It consist of an A to D followed with a look up table
 followed by a PWM generator all for $2.50 less programming and shipping:)

 Paul Lamar

 Craig replies;

 I think that is the best approach.

  Craig Taylor


 Is the mass flow vs. voltage chart real data (taken on an actual sensor)?

 I plotted it and then did a curve fit (two ways).  The curve fits
 reasonably well to an exponential regression..  I would think it
 possible to come up with an analog circuit that follows the curve
 reasonably well.  I believe the gain curve of many transistors (around
 Vt) is somewhat exponential..

 Then if needed, add some piece-wise comparator based tweaking to the
 pulse width - above a certain flow voltage, adjust the fuel up (or
 down) by a certain amount.

 I'm just saying, don't get scared into digital by the non-linear
 response of the MAF.  This is non-linear, but not in terrible way..
 If you go to digital (a lookup table), do so for other reasons.


 Matt-


I forgot to send my spreadsheet..


Matt-


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.