Subject: CAS Sensors -- WAS: MAF/uC FI Controller]
From: Rotary Engine
Date: 10/11/2009, 9:33 PM
To: AAA Put this in the To box

Okay, I'll chime in since you asked.  With all the time spent on 555
vs TI
vs Motorola and the boards and sensors, then we have return pumps, etc
-- I'm thinking it might be faster and easier to hand-build a
carburetor
from scratch.  Even if we made it from aluminum cans melted in
charcoal
forges in our backyards and poured into hand-built sand molds, it
might
be less work than the FI route.

Okay, wiseacre mode off and back to lurking.

Mark Waldron

Mark -

One reason for the delay in getting uC projects underway is that I
haven't found a reliable supply of silicon ingots for doing my own
circuit lithography and etching.  So, if you think melting aluminum
cans to make your own carburetor is tough, try jump starting your own
backyard silicon foundry with nothing more than sand for raw
materials.  (I only use sand from Newport Beach.)

Mark, if you can't hang with us hardass EE types, you better stick to
buying your carburetors.  :)

Peace/Love,
-Vince



-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.