Subject: CAS Sensors -- WAS: MAF/uC FI Controller
From: Rotary Engine
Date: 10/12/2009, 12:06 PM
To: AAA Put this in the To box




 Vince, I've been trying to follow what's going on with all these
 projects, so forgive me if my perceptions are lacking in correct
 information.  The flywheel CAS project, what are the design
 goals?  The rotational speed sensor you spec.  looks like
 something we would employ for an ABS system, but for triggering
 ignition, or actually determining the crank angle, wouldn't that
 require adding stuff to the flywheel?

 Just asking...
 C. Smith

The Flywheel CAS Project (not started) has the following points of
interest:
- CAS is *critical* in our application
- Provides an alternative to trigger wheel CAS
- May be used as a primary, secondary, or redundant CAS
- Flywheel sensors are safe from broken belts (obstruction hazard)

NOTE: Any work performed in the Flywheel CAS Project can be folded
into other projects, such as a Trigger Wheel CAS Project.  A trigger
wheel system will operate at lower frequencies, but will need a
"missing tooth" scheme added to reset the angle counter.

Which brings us to your last question: For the Flywheel CAS Project,
yes, I will have a second indicator/sensor on the flywheel to reset
the angle counter.  (We can't remove a tooth from the flywheel.)

STATUS:
This project is pending.  I have looked at sensors and helper chips,
and read up on Megasquirt's missing tooth algorithm, but that's about
it.  I intend to output multiple triggers to be fired at programmable
angles, for use by other projects (like the ill-fated 555/MAF project,
injection triggers, or ignition triggers).  Hopefully this will be a
building block to a complete engine controller project.

-Vince Orton

I'll-fated my butt :) The 555 is alive and well as soon as we get the super
$5 555 working. I intend to get a bunch programed for sale.


Paul Lamar

Paul, could you post a simple block diagram of how the new 5$ 555 chip connects to the MAF sensor and any other relevant chunks of the EFI system?  I'm confused on just how you plan to hook things together.  A brief discussion would also be very helpful.

 I think there is a major flaw in the concept, but I can't be sure with the information I have so far.

Craig Taylor


OK Here it is just replace the 555 with a 16 pin microcomputer.
I have not got around to updating the schematic yet.
We may do away with the trigger and let it free run with a built
in oscillator in the micro computer. First guess is a 16 ms period.

Paul Lamar



-- The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.






-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.