Subject: CAS Sensors -- WAS: MAF/uC FI Controller
From: Rotary Engine
Date: 10/12/2009, 12:15 PM
To: AAA Put this in the To box



Craig suggests;
Vince, have you looked at the Freon pressure sensors used on auto AC
systems?  Seems they would have all metal interfaces with the medium
under pressure.  Freon originally and gasoline/alcohol for your
needs.  Just a thought. You might need to work in the bottom 10-20%
of their operating range, but that might not be a problem.
<snip
These Stewart Warner fuel pressure sensors look interesting.
Available 15 to 150 psi full scale in 5 ranges.  They are variable
resistance with 240 ohms maximum at one end, 30 Ohms or so on the
other.

http://www.stewartwarner.com/Catalog/sdrpress.html

Craig Taylor

<snip
Look at Wika. Try the C 10. Available with 4 - 20 mA or 1 - 5 V.
These are
also calibratable and come in different ranges. They look like the
intake
pressure on the Mistral.

Dale Davies

Craig - I can look at the auto AC pressure sensors ... do you have
recommendations and/or links?  My gut feel is that working at the
extreme ranges of a sensor is a bad idea, but I'll check out whatever
you recommend.  You also recommended Stewart Warner gauge pressure
senders.  I have considered automotive gauge senders, but I am not
sure if they are "engine control" quality.  I'd welcome feedback from
knowledgeable engineers if it's appropriate to use a gauge sender unit
to control a PWM pump.  (These gauge-type sensor units vary resistance
from ~30 to ~240 ohms.)

Dale - I checked out the Wika site.  The sensors are WAY too expensive
for our purposes ($300+ if I read correctly).  It seems that they are
better suited for food industry requirements.  Any more leads?

Everyone - Thanks for helping out!

-Vince Orton

Vince,  I understand about the quality issue for auto type gauge senders.  They are most likely a variable resistor driven by a Bourdan (sp?) tube pressure sensor.  There would be a definite wear issue with any moving contact, variable resistor device.

Sorry, but I don't have any particular Freon pressure sensor in mind.  I suspect most of them are simple switch sensors.  BTW, there doesn't seem to be any reason to need a linear pressure sensor for your fuel system design if you are going to have a fixed pressure with a small variable range that is manually adjusted.  Just set up the system with an accurate (visual dial) test gauge.

Another thought is the low cost, silicon strain gauge type sensors produced by the semiconductor MEMS folks.  The problem there is the "mostly plastic" housings.  Not compatible with most fuels, I suspect.
But, it might be possible to install an adapter of some type that would isolate the fuel from the sensor.
I'm not sure how, exactly, this might work.  I see something like a rolling diaphragm with fuel on one side and a small volume of air on the other, with the air connecting to the actual sensor.  There are compatible elastomers (synthetic rubber) available.  Think of the accelerator pumps in carburetors.

Good luck!  Sounds like an interesting project.

Craig Taylor

-- The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.