Matt, this is what the initial files look like
 when a junk1 project is started. The board is up and running and
 LED are blinking :)

 --------------------------------------------------------

 This demo is pretty close to what we are looking for. About two pages.
 Not much.

 The Code Warrior  IDE is rather tricky as all projects are named
 "name.asm"
 everything must go in a separate folder.

 Here too is a short video of what the board is doing in the default
 demo.

 Paul Lamar

 <snip


 OK Paul.  That looks pretty familiar..  I'll see what I can put together.


 Matt-

 I am still trying to figure out this IDE. It is all Czech to me:)

 Paul Lamar


  There are some sourceforge.org IDE's and sim/emulators for 6800 family
  chipsets - although I have not used them so I don't know useful they are.
  Cary


 OK..  I found the included files - things like tasc0 and adr are
 defined there.  Kinda fills in some blanks between the device doc and
 the code example..


 Matt-

 Here is the IDE getting started instructions in C.
 I hope it is pretty much the same for asm.


 -----------------------------------------------------------

 Matt, any luck? Would a demo board and Code Warrior help?

 Paul Lamar


What would help me with projects/hobbies like this is not having a day job.  :)

I don't think there's that much difference between the demo program
and what you're looking for.  It's already reading the A-D converter -
but sending the value out the serial port.  I gather you want to have
the A-D value converted to a PWM output?

What's this business about the 8ms real time clock?  Is that to be the
period of the PWM signal?


Matt-


There is a timer device in there that will interrupt the processor every one ms.
This can be used to build a real time clock with a resolution of 1 ms.
Something I implemented back in the late 1970's in the road test system.

In this case I would like to use it to have the super 555 run on its own reading
the A To D every 16 ms and generating a PW pulse and outputting it to the injector switch.
No e-shaft trigger required. Saves a lot of hardware. Basically I suspect this is
what Tracy is doing as there is no time to sync the injection with e-shaft
position at 7500 RPM and still get a required injection pulse width of 90%
of 16 MS.

That A to D process and PWM process may only take a few hundred micro seconds
at most so between 16 ms real time interrupts the super 555 is twiddling its
thumbs sitting around doing nothing :)

Each ms contains 1000 micro seconds so the processor is loafing indeed:)

Paul Lamar