Paul,

I found a 89 rotor housing on Ebay so I will be sending you the housings when I get the one of Ebay. Another thing that I found was that the rotor that threw the seal trashed the apex slot so I will be using the rotors from the 86-88 motor.  So goes the quest for high compression ratios.  Do you want me to fit the seal plates or are you going to use the HF belt sander?  Can the old seal plates be updated for O rings?  I plan to get this motor running in the airframe to get all of the sub-systems working then drop in a RX8 motor. I will keep you posted.

Joe Berki
Limo EZ


We will fit the seal plates so if you have a set send them along.
People will have to smooth the welds and apply O-rings and red RTV to the
seal  plates. Then do a final pressure check.

Paul Lamar