Question:
I know that Lancairs have been flying IFR for years, but they have
certified engines, props and instruments.
According to FAA rules, can rotary engined experimental with IFR
instruments and IFR certified CS prop be registered as
IFR-certified, or
"IFR approved" ?
Or should the engine be also IFR certified to start with, like eg.
IO-360? This has some connections to PSRU project...
Please comment. Did I forgot something?
Cheers,
Petri
Question, what is an "IFR certified" powerplant or prop?
C. Smith
There is no IFR certification by the FAA of experimental aircraft. The
standard operating limitations issued by the FAA for Experimental
(Amateur Built) specify Day VFR operation "unless equipped for night VFR
and/or IFR in accordance with FAR section 91.205. The representative of
the Administrator issuing the Airworthiness Certificate and accompanying
Operating Limitations may add any other limitations they feel necessary
for safety, so it would be prudent to discuss this issue with the
persons you consider to employ for certification of your airplane.
Choose a DAR who is not antagonistic towards rotary power. Both my
IO-470 powered RV-8 and my Subaru-powered (all-electric, fuel injected)
RV-6 have the preceding language permitting IFR if equipped per Part 91.
Victor Roberts
I'm fully aware of all of this Victor, which is why I asked the
question,
what is an IFR certified engine or prop.
A "aircraft" is certified for operation as IFR, an experimental gets an
airworthiness certificate with operating limitations.
Powerplants and props get certification for use on certificated
aircraft,
but I'm not familiar with the "IFR" bit as it pertains
an engine or propeller, and would like to know more about this.
Thanks.
C. Smith
Hi,
My question could be set confusingly, I am not familiar with the
procedure how FAA gives permits for IFR flying for experimental
aircraft. I just know that it could and has been done.
That talk about IFR certifed prop and engine has it's origin on some
shady bits of information like "you cannot get IFR with xxx prop" and
"you need redundant systems to get a single IFR certified".
What's interesting is how auto engine conversion like rotary engine mix
with this - does 13B count as "sufficiently verified" design or should
one expect difficulties when trying to get that IFR certification.
Victor's reply implies that the result depends on the DAR's attitude.
(Designated Airworthiness Representative?)
Has anybody tried this yet?
Cheers,
Petri
It is very much a function of the DAR's experience, training, and
attitude. The DAR is designated by the Administrator to certify that the
experimental aircraft is safe to operate within the limitations that DAR
issues along with the Airworthiness certificate. The DAR takes into
account good engineering and design standards, use of appropriate
materials, appropriate technical data, and then renders an opinion as to
whether the machine is approved or not, and any limitations he feels are
necessary for safe operation.
It is common knowledge that some every Flight Standards District Office
(FSDO) has it's own internal guidance in some areas which are in direct
conflict with other FSDO guidance. Knowledgeable Manufacturers will
perform certification of products under different FSDOs by locating
engineering and research facilities away from production facilities in
order to obtain reasonable certification requirements.
One old-line gyro manufacturer spent several years trying to get a
solid-state attitude indicator approved because the FSDO was unwilling
to be the first to approve a low-cost stand-alone device.
Before you select a DAR, interview several and ask them directly about
issues you are concerned with. Most will be very clear up-front about
the things they consider essential, and things they would not approve.
Victor Roberts
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.