Subject: Cart before the horse
From: Rotary Engine
Date: 10/18/2009, 12:32 PM
To: AAA Put this in the To box


Perhaps before we start talking about systems we would like to see developed
maybe we aught to consider the target engine.

1, HP range?
2. Powerplant weight?
3. Specific airplane series application?
4. Engine life? Lycoming did not acheive 2000 overhaul life for several
generations. Most homebuilts do not see 500 hours in their lifetime.
5. Safety first and above all.

Once these factors are in hand then strike out for the details.

Just a thought,


Milo




Are you considering engines other than a Mazda based rotary engine?

I am confused? What is your point Milo?

What is the matter with 250 HP on a bare block 200 pound cast iron
side housings Mazda engine? Less gear box and accessories of course.

As far as I know nobody has worn one out yet and some have gone 2400
hours in gyrocoptor trainers. Projected life, based on the wear rate of
ceramic apex seals, is 30,000 hours. There is no part in a Mazda engine,
unlike piston engines, that is subject to fatigue failure. The e-shaft
and rotor have never cracked. The only three moving parts.

You must of course keep it cool and keep it properly lubed.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.