Subject: slide throttle and SS P-port fab partts and shipping addresses.
From: Rotary Engine
Date: 10/19/2009, 11:22 PM
To: AAA Put this in the To box


Paul,

Who would I contact to order a slide throttle and SS p-port installation.

Again, I 've been out of the loop for awhile and alot of recent talk pertains

to the RX8 engine with regard to slide throttle and SS p-port fab.

Are these parts compatable with my 2nd gen 13B



Thanks,Geir Andersen

You can buy the slide throttle kit parts from me. The prices are on the
web site. No checks no CC's, or money orders. Cash green backs only.
You will still need to buy .032 thick Teflon from McMaster Carr or Scientific
Commodities in Lake Havasu that runs about $28.00 a sheet.

Rotary housings are pretty easy to do yourself if you have access to a mill.

Right now we are in the process of doing a group buy on p-port rotor housings.
When ten people have sent us their rotor housings we will set up the mill,
bore the holes, tig weld in SS tubes and bolt on a sealing plate on the outside.
You will need to finish the inside with a Dremel tool sander.

Cost for that service is $150 each... cash only, no checks, no money orders.
Plus shipping cost back to you.

We will let you know when we are ready to ship and then you can send
the money. Check the rotor housings width for shrinkage. You will need a 3 inch
to 4 inch micrometer. You can get a low cost version at Harbor Freight.

Shrinkage is a sign of a severely over heated engine making the rotor housings
useless. We see much less of this since Mazda changed the alloy about 20 years ago.

We currently have six so we need four more to get started. Then we will wait for
another ten.

Shipping address for rotor housings is:

Paul Lamar C/O
Light Speed Engineering
416 E. Santa Maria Street,
Hangar #15, Santa Paula, CA 93060


Mailing address for all other part orders is:

Paul Lamar
830 East Santa Maria St.
Suite 303
Santa Paula, CA
930060

For more info see:
http://www.youtube.com/profile?user=UTUBPLEASE#p/u/24/LkKw72dZ2yc
http://www.youtube.com/profile?user=UTUBPLEASE#p/u/39/KQL45DYgIFw

http://www.rotaryeng.net/Mazda_R26B_US.pdf
http://www.rotaryeng.net/intake.html


Paul Lamar

        Thanks Paul

What is the benefit of the RX8 with ,I believe side port exhaust to the 2nd gen I have

Geir Andersen               

The side exhaust makes the RX8  p-port equivalent to an ordinary 13B as far as port
timing is concerned. That gives it a better idle. The side exhaust also
is a couple of hundred degrees F cooler so the muffler does not catch
quite so much hell.

Paul Lamar


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.