Subject: 20B on Seawind mount
From: Rotary Engine
Date: 10/23/2009, 11:49 PM
To: AAA Put this in the To box


HI Paul,

A friend of mine just got his aluminum 20B mounted on his standard
Seawind frame.  He said it was recently tested for 6Gs in all
directions.  I notice he is using a dry sump which frees up the space
underneath for some heat exchangers.

Ignore the portable drill sitting on top of the PSRU.  It will probably
be removed before flying:)

I can't determine how the top CNC mount is attached but knowing Russ it
probably has a lip machined in it to catch the housing as well the use
of the through bolts.

Doug in Japan.


Paul

I like the approach Russ has done on the 1/4" bended Al plate lower
mount.  Each one was tested to three tons compression which is over
kill.  I wonder if the two plates work better as one unit though. A good
place for an Setrab oil cooler is created.

Some options are to angle the lower Al. mount farther forward and pick up
more oil plate bolts.
An oil pan could still be  included in the design as long as space is
left for air flow out the back of the oil cooler.   Dry sumps are good
because of their robust flow, though adding a turbo into the mix mean
the return has to scavenged as well.  I prefer gravity drain with a
pressurized accumulator to provide a little oil flow upon  shut down. A
water counter flow heat exchanger could be on the top rear of the motor
mount.

The top mount is my concern.  I would prefer the load paths to go forward
nearer to the PSRU end  to unload the added stress applied to the engine
tension bolts. Should be an easy fix with a few  steel tensioning rods.
All over Russ has helped me a lot.

Doug in Japan.


I can't really comment on it as there are not enough
pictures to see all the details.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.