Hello Jeff,
That is one good looking adapter plate!!
My understanding of the advantage when using the s-beam mounting is
that the center of mass of the FWF assembly is mostly on the beam
mounts. I remember talk of static weight on the rear mount being
about 9 lbs and measured stress at full power being about 50 lbs.
Does the new mount/adapter plate move the mounting point
forward enough that the rear mount needs to be redesigned for higher
stress?
Also, with redesign of the PSRU to a lighter weight even more stress
will be put on the rear mount (but not much).
My big concern is with a single rotor and lighter weight, the s-beam
mount might be too far towards the prop. Could the mount instead be
incorporated into the engine end plate and then use a bell housing
type adapter for the PSRU? Reducing part count and weight is always
my goal. Is this idea practical?
Someone suggested a carbon fiber bell housing. The company that makes
TrickAir skis and the composite parts for the Arion airplane is about
40 miles from me. Should I get a preliminary price? (to compare with
machining/spinning/draw forming from aluminum)
Regards,
Dan
Dan
I am not sure how the engine is mounted on the rear. I will forward this
question to Paul, I am sure he has the answer your looking for..Stay
away from the carbon fiber idea on the bell housing.............when
carbon goes, it goes suddenly and catastrophically..It is really
difficult to thread into carbon, you need special inserts that are well
supported that add weight, super expensive...A well made aluminum or
magnesium can be very light and economical....
jeff
Yes there is a bit more static load on the rear mount.
If you take thrust into consideration and its moment around the
low mounted front rubber bushings, the load on the rear
mount could still go to zero under some thrust conditions.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.