http://www.autoblog.com/2009/10/20/report-mazdas-design-chief-working-on-new-rx-7/
Marc Weiese
"We've been hearing rumblings about a Mazda RX-7 revival for so long, we've almost gotten numb to
the idea of a next-generation, rotary-powered coupe. But Mazda's new design chief, Ikua Maeda, has
given us a desperately needed hope injection when he told Autocar that initial sketches have been
completed and he's campaigning Mazda execs to bring the new sports car to market.
The reborn RX-7 will likely be powered by Mazda's next generation Renesis 16X rotary engine, most
recently seen in the Mazda Taiki concept, displacing 1.6-liters and making use of a longer stroke,
direct injection and aluminum side housings. Outputs haven't been disclosed, but it's safe to assume
the new mill will put out around 250 to 300 horsepower and a sizeable increase in torque, while
boosting fuel economy and reducing emissions (and hopefully burning less oil in the process).
Maeda says the new RX-7 will move further upmarket than its predecessors, with a focus on higher
interior quality going forward. Fine by us, but we hope a hardcore, track-focused version is in the
cards as well. And if Maeda is to be believed, we could see the fruits of his labors in concept form
as early as next year."
End of quote.
Burning too much oil? Baloney. I don't know why these dumb journalist cannot get right.
Mazda shot themselves in the foot as the RX8 did not burn enough oil. Mine goes 3,000
miles between quarts. That led to problems with the apex seals. I have been adding one ounce
of 2 cycle oil to the fuel gallon ever since I got it.
They always have to inject something negative into their rantings.
Paul Lamar
Does that effect emissions when you go to get it tested .
Cifton
Yes of course.
You stop doing it for a tankful or so before emissions testing is required.
Just don't do any high power stuff during that period.
I forgot to mention Mazda addressed the problem around 2007 with a third
oil injector in each rotor housing. I suspect they underestimated the
effect combustion heat had on apex seal temperature. They assumed most of the
apex seal heat was due to the peripheral exhaust of the previous engine.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.