Subject: Al. P. port plates.
From: Rotary Engine
Date: 10/28/2009, 9:39 AM
To: AAA Put this in the To box




Paul

I noticed you have installed the PP plates with bolts from the outside.
May I make a suggestion that you use studs? Use big washers and nuts and then  torque the plates down until the RTV sets up overnight.  After that you will have a nice mounting platform for the manifold, and throttle  combination.  Seal the inner threads when the studs are installed of course or water will spiral up and out. I noticed you saw the wisdom of O-rings over smeared RTV.  Sure hard to beat O-rings for sealing but then Mazda discovered this years ago:)

Doug in Japan


Paul
 I sent my sealing plates back to you for the O-Ring modification just wanted to see if you received them ok?

Mike C.

Yes I have them Mike. BTW that optically clear low viscosity RTV is $275 a pint!!!!!

Paul
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.