Subject: 20B Overhaul -water pump
From: Rotary Engine
Date: 11/2/2009, 6:12 PM
To: AAA Put this in the To box


3) Anyone know parts numbers for the water and oil pumps from the 20B or
maybe a supplier you've used that caries them?

Jay


Hi Jay;
  From what little I remember, the 20B's were somewhere between 2nd and
3rd gen.
A good place for used parts and information is rx7club.com.  See also
nopistons.com
There are several forums you can search or post a want to buy thread:
    http://www.rx7club.com/forumdisplay.php?f=95
    http://www.rx7club.com/forumdisplay.php?f=99

    http://www.mazdamotorsports.com

You can supposedly still order Cosmo/20B parts through your Mazda
dealer.  Some people seem to have a full Cosmo parts fiche.  See this
thread for hints (I should have bought that car):
    http://www.rx7club.com/showthread.php?t=788077&highlight=cosmo

Some of the engine parts are here:
    http://cp_www.tripod.com/rotary/pg20.htm
Cosmo:
    http://cp_www.tripod.com/rotary/pg09.htm

possibly:
   http://www.partsnet.com.au/members.html

Cheers
Cary

Paul,
Here are some photos of the original water pump and housing side by side
with the one I got from Atkins. I also included one of the front end
housing. The oil pump is going to fit. So for now I'm just dealing with the
water pump issue. Dan at Atkins suggested an 86'-91' pump and housing would
fit the 20B without any fabricating or cutting. Can you corroborate this?

Thanks
Jay

Your original pump is fine Jay. No need for the 3rd gen cartridge besides the
that fact that it does not fit the 20B water pump housing. I'll take a closer look at my
20B out in the hangar and see if I can find any disadvantages to sticking with the
original pump.

You may have to cut it down to fit under your cowl but that would be true of a 2nd or
3rd gen water pump housing as well.

Paul Lamar

The front cover looks unique to the 20B but I am not sure. Mainly in the area of the oil drain back for the sequentially turbos.


Please take a picture of the front cover both from the front and rear so we can tell if it will fit a 2nd gen water pump housings. Also please take a picture of the 20B front end housing from the front.

The cartridge Dave Atkins sent you is a 2nd gen 8 bolt version. In order to use that you would need a 2nd gen water pump housing which may or may not fit your front cover.

The only drawback I can see  sticking with the 20B WP pump is the difficulty in finding a new cartridge if it develops a leak or the bearings go out. They can be pressed apart and the bearings replaced but that is what most people don't do. They just replace the cartridge.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.