I finally had success getting the shaft split. The pry and pound method
worked and fairly easily at that.
I recently ordered both a water and oil pump from Atkins. I got to
looking this afternoon and neither of them is even close to fitting my
engine. I have parts numbers from
http://cp_www.tripod.com/rotary/pg20.htm but they don't appear to do
many any good with any supplier I've found so far. Tracy Crook told me
he used a 13B water pump on his 20B and he thought the oil pump was the
same as a 13B as well.
1) Is there a way to get my engine serial number and DOM off the engine
somewhere? So far I've been unable to determine either.
2) Is there a rule of thumb for ordering 13B parts to be used on a 20B
as in year model equivalents? IOW for example 93-95 RX7 parts normally
fitting a 20B. I was thinking the 20B was in production from 90' - 96'
so I was assuming 13B parts from those years would generally fit.
3) Anyone know parts numbers for the water and oil pumps from the 20B or
maybe a supplier you've used that caries them?
Jay
Jay, Take some pictures of the front end housing, the front cover, the
water pump Dave Atkins sent you and the oil pump. It is possible to
build a 3 rotor by mixing and matching parts from many years of 13B's.
When somebody says they have a 3 rotor it could be almost anything.
Some of that stuff on tri pod is of a 13G racing three rotor which is
significantly different in the area around the front cover and the
intake.
Who did you buy the engine from? Was it a Japanese engine out of a
wreck.
I assume not as you are looking for a water pump and oil pump which
would have arrived with real 20B parts.
Paul Lamar
Paul,
I'll take some pics later today. I got the engine from JDM through Ebay
it supposedly had 60K miles on it. It came with the oil and water pumps.
But since I was putting it in an experimental aircraft just for good
measure I thought I'd replace most of the accessories.
Jay
IMHO the stock parts are the best to use. In the late 13B shop manual
there is a procedure for measuring the wear on the oil pump. If that
comes out OK I would use it.
You may have to cut the water pump down but that is not hard. Since we
are getting setup to do rotor housings tooling wise we could do water
pumps one at a time for $200. We are unlikely to get ten at a time to do
but if that ever happens the price could come way down due to mill set
up cost. I have done a couple already. The RX8 water pump does not have
to be cut down. It is as low profile as it can get.
Paul Lamar
Paul
Where did you get that nice filler neck in step 9?
Tom/norpro
That is a 3rd gen RX7 engine and it is mounted on the thermostat housing.
Part number 15-175B and 15-174A O-ring.
You can download the parts books from:
http://foxed.ca/foxed/index.php?page=rx7manual
This link is on the web site.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.