Subject: 20B Overhaul correct parts to use.
From: Rotary Engine
Date: 11/2/2009, 6:46 AM
To: AAA Put this in the To box





-----Original Message-----
From: Rotary Engine [mailto:rotaryeng@earthlink.net]
Sent: Sunday, November 01, 2009 11:26 PM
To: AAA Put this in the To box
Subject: 20B Overhaul



I finally had success getting the shaft split. The pry and pound method
worked and fairly easily at that.

I recently ordered both a water and oil pump from Atkins. I got to looking
this afternoon and neither of them is even close to fitting my engine. I
have parts numbers from http://cp_www.tripod.com/rotary/pg20.htm but they
don't appear to do many any good with any supplier I've found so far. Tracy
Crook told me he used a 13B water pump on his 20B and he thought the oil
pump was the same as a 13B as well.

1) Is there a way to get my engine serial number and DOM off the engine
somewhere? So far I've been unable to determine either.

2) Is there a rule of thumb for ordering 13B parts to be used on a 20B as in
year model equivalents? IOW for example 93-95 RX7 parts normally fitting a
20B. I was thinking the 20B was in production from 90' - 96' so I was
assuming 13B parts from those years would generally fit.

3) Anyone know parts numbers for the water and oil pumps from the 20B or
maybe a supplier you've used that caries them?

Jay

Jay, Take some pictures of the front end housing, the front cover, the water
pump Dave Atkins sent you and the oil pump. It is possible to build a 3
rotor
by mixing and matching parts from many years of 13B's. When somebody says
they
have a 3 rotor it could be almost anything.

Some of that stuff on tri pod is of a 13G racing three rotor which is
significantly
different in the area around the front cover and the intake.

Who did you buy the engine from? Was it a Japanese engine out of a wreck.
I assume not as you are looking for a water pump and oil pump which would
have arrived with real 20B parts.

Paul Lamar

Paul,
I'll take some pics later today. I got the engine from JDM through Ebay it
supposedly had 60K miles on it. It came with the oil and water pumps. But
since I was putting it in an experimental aircraft just for good measure I
thought I'd replace most of the accessories.

Jay

IMHO the stock parts are the best to use. In the late 13B shop manual there is a procedure for measuring the wear on the oil pump. If that comes out OK I would use it.

You may have to cut the water pump down but that is not hard. Since we are getting setup to do rotor housings tooling wise we could do water pumps one at a time for $200. We are unlikely to get ten at a time to do but if that ever happens the price could come way down due to mill set up cost. I have done a couple already. The RX8 water pump does not have to be cut down. It is as low profile as it can get.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.