Subject: Barry bushings installed on Jeff's MM Plate
From: Rotary Engine
Date: 11/2/2009, 6:28 AM
To: AAA Put this in the To box


  Another tidbit of info.

  Paul Lamar




  Paul

  you got me worried, is this good or bad???????????


  jeff

  They fit perfectly. You did a great job. The 1/2 inch bolt is supposed
  to compress the rubber a bit. New bushings come with a large steel
  washer that goes on top.

  Paul Lamar

  Wheeeeeeeewww....................!!!!!!

 Jeff

 Here is just about everything partially assembled on a p-port RX8 engine.

 Paul Lamar

Looks very nice. Are you planing on having the intake runners leaned over
like in the last few pics? Seems like getting a fuel rail attached would be
a RPITA. Is that the engine that's going in your never ending project plane?

Vlad

If you lean over the tubes to give more room under the cowl you can rotate the
injectors holders so all injectors line up for one fuel rail.

BTW the tubes have not been cut to the proper lenth yet.

Also Jeff has not sent me the new spacers yet. What is shown is a couple
of Tracy's spacer blocks.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.