Subject: Barry bushings installed on Jeff's MM Plate
From: Rotary Engine
Date: 11/2/2009, 11:27 AM
To: AAA Put this in the To box

Another tidbit of info.

Paul Lamar


Paul

you got me worried, is this good or bad???????????


jeff

They fit perfectly. You did a great job. The 1/2 inch bolt is supposed
to compress the rubber a bit. New bushings come with a large steel
washer that goes on top.

Paul Lamar

Wheeeeeeeewww....................!!!!!!

 Jeff

 Here is just about everything partially assembled on a p-port RX8
 engine.

 Paul Lamar

 Looks very nice. Are you planing on having the intake runners leaned over
 like in the last few pics? Seems like getting a fuel rail attached
 would be a RPITA. Is that the engine that's going in your never ending project
 plane?

 Vlad

 If you lean over the tubes to give more room under the cowl you can
 rotate the injectors holders so all injectors line up for one fuel rail.

 BTW the tubes have not been cut to the proper length yet.

 Also Jeff has not sent me the new spacers yet. What is shown is a couple
 of Tracy's spacer blocks.

 Paul Lamar


I will be sending the spacers to all as soon as I get back in
town......The round rod spacers will be like TC but the block spacer
will look like this.....and weight much less..........

jeff


That is real cool looking Jeff.

Paul Lamar
--

Jeff,

I bet you could sell a bunch of lightweight spacers to the rest of us.  What
do you say?

Mark S.

I agree! That could be a big seller as no need to change your existing
motor mount.

Actually the same thing could be said about the adapter plate. You
don't need to use the motor mount part. Just saw it off and save some
weight over Tracy's plate.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.