Subject: Barry bushings installed on Jeff's MM Plate
From: Rotary Engine
Date: 11/3/2009, 5:24 AM
To: AAA Put this in the To box

Another tidbit of info.

Paul Lamar


Paul

you got me worried, is this good or bad???????????


jeff

They fit perfectly. You did a great job. The 1/2 inch bolt issupposed
to compress the rubber a bit. New bushings come with a large steel
washer that goes on top.

Paul Lamar

Wheeeeeeeewww....................!!!!!!

Jeff

Here is just about everything partially assembled on a p-port RX8
engine.

Paul Lamar

Looks very nice. Are you planing on having the intake runners leanedover
like in the last few pics? Seems like getting a fuel rail attached
would be
a RPITA. Is that the engine that's going in your never ending project
plane?

Vlad

If you lean over the tubes to give more room under the cowl you can
rotate the
injectors holders so all injectors line up for one fuel rail.

BTW the tubes have not been cut to the proper length yet.

Also Jeff has not sent me the new spacers yet. What is shown is acouple
of Tracy's spacer blocks.

Paul Lamar


I will be sending the spacers to all as soon as I get back in
town......The round rod spacers will be like TC but the block spacer
will look like this.....and weight much less..........

jeff


That is real cool looking Jeff.

Paul Lamar

Amazing!  Have you considered mods to the forward part of the redrive
to remove excess aluminum?

Chris Cosman

We are we are working on it. I think we can get 15 pounds out.

Paul Lamar

Do you want my TC RD1-C front end for the work up???
C. Smith

No thanks.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.