Another tidbit of info.
Paul Lamar
Paul
you got me worried, is this good or bad???????????
jeff
They fit perfectly. You did a great job. The 1/2 inch bolt is supposed
to compress the rubber a bit. New bushings come with a large steel
washer that goes on top.
Paul Lamar
Wheeeeeeeewww....................!!!!!!
Jeff
Here is just about everything partially assembled on a p-port RX8
engine.
Paul Lamar
Looks very nice. Are you planing on having the intake runners leaned
over
like in the last few pics? Seems like getting a fuel rail attached
would be a RPITA. Is that the engine that's going in your never
ending project
plane?
Vlad
If you lean over the tubes to give more room under the cowl you can
rotate the injectors holders so all injectors line up for one fuel
rail.
BTW the tubes have not been cut to the proper length yet.
Also Jeff has not sent me the new spacers yet. What is shown is a
couple
of Tracy's spacer blocks.
Paul Lamar
I will be sending the spacers to all as soon as I get back in
town......The round rod spacers will be like TC but the block spacer
will look like this.....and weight much less..........
jeff
That is real cool looking Jeff.
Paul Lamar
--
Jeff,
I bet you could sell a bunch of lightweight spacers to the rest of
us. What
do you say?
Mark S.
I agree! That could be a big seller as no need to change your existing
motor mount.
Actually the same thing could be said about the adapter plate. You
don't need to use the motor mount part. Just saw it off and save some
weight over Tracy's plate.
Paul Lamar
I could make light weight spacer for all.. Just would like to know how
much interest is out there..The idea of cutting the pate down is like
hearing finger nails on the chalk board. If there is a need for
plates
more like TC, make them and tell Tracy to leave it out of his kit with
the appropriate reduction..
Seem like there is areal need for decent water pump housing, OEM is a
real clunker....
jeff
There is a limited market for cut down motor plates with no motor
mounts.
My guess you will find less than five people willing to spend $250
to take
out 2 or 3 pounds out of a flying example.
We need things with a higher priority than water pumps. The 2nd gen
and 3rd gen engines
will become more scarce as times goes on and the RX8 pump is fine as
is.
Also there is a light weight low cost aluminum cartridge already
available for the 2nd gen and 3rd gen pumps.
Now 15 pounds out of the gear box with a $1000 dollar saving is
another matter :)
Paul Lamar
Could always revisit the aluminum end and intermediate housings with
steel wear surfaces idea. Jabiru is machining their entire engine.
Richard Sohn has already proved the approach works. Of course, with
RX8 housings the exhaust would be a challenge...
Chris Cosman
That is not what I had in mind. I was talking about a new gear box with way less
technical risk. The market would be much larger than for an aluminum end housing.
Paul Lamar.
Paul could you tell me who design this PSRU
Jean Prudhomme
I did.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.