Subject: 20B Mods: Rotors, Water Pump, Front Cover
From: Rotary Engine
Date: 11/4/2009, 10:22 AM
To: AAA Put this in the To box



When I disassembled my 20B last week, I was pleased that all the rotor
housings were in good shape and there was no evidence of overheating.  All
apex seals moved freely and I didn't see any significant problems except
one......The front side housing had a spot the size of a dime that was deeply
pitted as if a single drop of water sat on the iron for a long time  causing
it to rust and pit, although there wasn't any rust.  I'm not  comfortable
reusing it, so I'm going to get a new one !!!  So the  question arises....since
I have to replace it anyway, should I just get a new  20B front side
housing and modify the water pump (which is still a big  heavy beast), or is it
possible to just use another parts combination?  In  addition, I would also
really like to use the RX8 Rotors if they will work  because they are lighter
and have a 10:1 compression which would be great for my  normally aspirated
application?.......

I remember recently reading a post from someone in this Group who is
building a 20B with RX-8 Rotors, Front Cover, Water Pump and CAS.  I  remember
him making the statement that the RX8 CAS is much better (but I don't  know
why that is).  Paul, do you know who that was and if he has been  successful
at making everything work?  And what is better about the  RX8 CAS?

Thanks,
Don

I think you can use a 3rd gen RX7 front housing. Maybe even a RX8 front housing. Check with Mazdatrix on that. They sell them as well. Ask them about the RX8 rotors while you are at it and report back what they say.

562-426-7960 For Parts Ordering, and General info
562-426-4460 For Local Service and Parts

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.