Subject: 20B Mods: Rotors, Water Pump, Front Cover
From: Rotary Engine
Date: 11/4/2009, 2:17 PM
To: AAA Put this in the To box


When I disassembled my 20B last week, I was pleased that all the rotor
housings were in good shape and there was no evidence of overheating.  All
apex seals moved freely and I didn't see any significant problems except
one......The front side housing had a spot the size of a dime that was
deeply
pitted as if a single drop of water sat on the iron for a long time
causing
it to rust and pit, although there wasn't any rust.  I'm not  comfortable
reusing it, so I'm going to get a new one !!!  So the  question
arises....since
I have to replace it anyway, should I just get a new  20B front side
housing and modify the water pump (which is still a big  heavy beast), or
is it
possible to just use another parts combination?  In  addition, I would
also
really like to use the RX8 Rotors if they will work  because they are
lighter
and have a 10:1 compression which would be great for my  normally
aspirated
application?.......

I remember recently reading a post from someone in this Group who is
building a 20B with RX-8 Rotors, Front Cover, Water Pump and CAS.  I
remember
him making the statement that the RX8 CAS is much better (but I don't
know
why that is).  Paul, do you know who that was and if he has been
successful
at making everything work?  And what is better about the  RX8 CAS?

Thanks,
Don

I think you can use a 3rd gen RX7 front housing. Maybe even a RX8 front
housing. Check
with Mazdatrix on that. They sell them as well. Ask them about the RX8
rotors while you
are at it and report back what they say.

562-426-7960 For Parts Ordering, and General info
562-426-4460 For Local Service and Parts

Paul Lamar



--------------------------------------------------------------------------------

Paul, as I remember when using late model 13B housings housings to make up a
three rotor using a mixture of 20B and 13B parts, some of the differences
are that two of the tension bolts for the 20B are larger diameter and
require milling the corresponding holes to proper size in the 13B parts.

Steve Beckham


Thanks Steve. I had not heard that before.  I knew they were longer.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.