Thank you everyone for you advice... The 2 1/8" 3/4" drive socket $32 from sears and 3/4" impact hammer from Harbor freight $99 is the way to go... It literally took 2 seconds to take the bolt off... Really helps if you have the right tools for the job.
The engine is all apart and the Rotor housings are in the Mail; Fed EX Tracking # 832292610033207...

Paul, I will mail the $$ on Monday for the P-Porting and SS tubes... Also, I sent my Sealing blocks back to you a few weeks ago for the O-Ring Modification... Please let me know if you didn't get them.  For the $$, I was going to send $340... $300 for P-Porting and $40 for the tubes... I assume there will be additional costs such as shipping and welding ect so I'll wait to hear from you on the Balance if that's ok?  Again, Thanks ALL for the advice there were may good ideas.

Mike C.




--
Hi Paul
  Fed Ex shows that my Rotor housings were delivered... Please verify you received them ok.

Thanks

Mike C.

I think so. When did they deliver them?. I have not checked with Klaus in the past couple of days. I'll go out there later today.


Paul Lamar