Subject: Stumbling during throttle advance
From: Rotary Engine
Date: 11/6/2009, 7:30 AM
To: AAA Put this in the To box


 Hello Paul-

 Getting ready for 'first' flight again & we've been able to replicate the
 engine anomaly that was reported when we had our mishap last time.

 Seems that when the engine is running between 4000 - 4500 rpm & the
 throttle
 is smartly advanced, the engine will stumble for ~ 1 second before running
 steadily again.  We can replicate this with no problem -- it happens every
 time.  If the throttle is slowly advanced, the engine smoothly increases
 in
 rpm with no hint of a stumble.  We also tried this with the mixture set
 full
 rich -- stumble seemed worse / longer, and with full lean -- stumble
 seemed
 less, but did not go away.  If the engine is running below the 4000-4500
 range (say 3000) and the throttle is smartly advanced to WOT, the stumble
 doesn't seem to happen.

 We tried to track the MAP values to see if anything seemed odd during
 these
 tests.  Unfortunately, it seems we've developed an electrical problem with
 either the EC2 or the EM2 -- they're not talking to each other, so we had
 no
 way of displaying what was going on as the engine ran.  We spent a while
 debugging that issue & ruled out obvious causes.  (Tracy suggests we check
 for good ground between the two devices & it that is solid then they need
 to
 get sent back for testing).

 Do you suppose this behavior (the stumbling) just means we have more MAP
 adjustments to make (once we get the electrical issue sorted), or could
 the
 slide throttle implementation have anything to do with it?  Just trying to
 eliminate things to be checked...

 Thanks,

 Mark & Terry

 Move the throttle slowly :) Let them eat cake :)

 Does it happen during injector staging when the MAP is around 15 inches of
 HG?
 Making it richer in that area should fix it. Perhaps making it leaner as
 you already tried richer. It should have nothing to do with the throttle
 as you are measuring the MAP inside the rotor housing. Carbs handle this
 problem with an accelerator pump which temporarily richens the mixture.
 EFI's uses a throttle position sensor but Tracy does not like those.

 My C182 engine will stumble if you slam the throttle open. No accelerator
 pump on the carb. At least I don't think there is one.

 Paul Lamar


Paul,
this is why automotive ecu's have a throttle position sensor. The computer
uses the injectors as the accelerator pump by increasing the pulse width
momentarily above what the map has given.
I don't think Tracy's unit supports this, but being gentle with the throttle
does.
Larry


Mark, set the data acquisition system to 2000 samples per second and monitor the pressure at the output of the pressure taps on the rotor housings.


Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.