Subject: oil gallery O-rings and tension bolt seals
From: Rotary Engine
Date: 11/6/2009, 8:57 AM
To: AAA Put this in the To box


OK, that makes more sense.  I'll use 8.93 and 11.21".

Thanks,
Mark

Paul,

I have one question regarding the oil galley o-rings.  I measured those at
.628" ID, .862" OD, and the o-ring cross-section (which had taken a set and
was oval-shaped) at .065" - .085" , so that would average out to .075".  Does
this sound correct?  I counted 12 of these, but may order a couple of
extras.

Does McMaster sell the tension bolt seals?

Thanks,
Mark

Here is the Creavey chart. Look at the groove dimensions and the squeeze and choose the one that works the best. The depth of the slot in the rotor housings is .070.
The width is 8.62--.628 = .234 / 2 = .117" wide.
The controlling factor would be the squeeze so my guess would be a section diameter of 0.093. There is plenty of room laterally for it to expand.

If you talk to Jeff ask him if he makes O-rings in metric sizes.
--------------------------------------------------------------

Yes. McMaster Carr key words "Metric sealing washers". Tracy was passing out plain washers with O-rings and hoping for the best :)

McMaster part number 93786A175 .......85 cents each


Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.