OK, that makes more sense. I'll use 8.93 and 11.21".
Thanks,
Mark
Paul,
I have one question regarding the oil galley o-rings. I measured
those at
.628" ID, .862" OD, and the o-ring cross-section (which had taken a
set and
was oval-shaped) at .065" - .085" , so that would average out to
.075". Does
this sound correct? I counted 12 of these, but may order a couple of
extras.
Does McMaster sell the tension bolt seals?
Thanks,
Mark
Here is the Creavey chart. Look at the groove dimensions and the
squeeze and choose the one that works the best. The depth of the slot
in the rotor housings is .070.
The width is 8.62--.628 = .234 / 2 = .117" wide.
The controlling factor would be the squeeze so my guess would be a
section diameter of 0.093. There is plenty of room laterally for it to
expand.
If you talk to Jeff ask him if he makes O-rings in metric sizes.
--------------------------------------------------------------
Yes. McMaster Carr key words "Metric sealing washers". Tracy was
passing out plain washers with O-rings and hoping for the best :)
McMaster part number 93786A175 .......85 cents each
Paul Lamar
The stock Mazda tension bolt washers are relatively cheap.
Some other metric washers have a true captured oring. Also look for
"stat-o-seal". Parker industrial and specialty shops carry them.
You should also be made aware that the optimal o-ring diameters from
different generations are slightly different. The sizes above should
work fine, BUT, additional care is required on installation. Hopefully,
these are correctly sized so they do not need to be stretched. A bunch
of failures were discussed here years ago.
Cary
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.