Subject: exhaust Inserts and housing temperature equalization.
From: Rotary Engine
Date: 11/7/2009, 7:46 AM
To: AAA Put this in the To box


  Regarding the 20B exhaust inserts - I think that was me, sort of.
  I have a vague memory that the 20B exhaust is more restrictive than the
  13B.   People have swapped out the inserts or just used 13B housings as
  the 20B housings are less common anyways.
  Turbos quiet the exhaust considerably while they last.  Inserts also
  smooth out the flow and may help turbos live longer as well.  Turbos a
  little downstream would also help. <hint



http://foxed.ca/rx7manual/manuals/Training%20Manual/4._Fuel_&_Emission_Control_Systems.pdf
  ;
  p18
  For an NA, the NA inserts are worth 7-8db IIRC (which is a LOT, sorry
  can't remember the source) and help keep the exhaust stack together
  longer.  You can port the exhaust port and keep the NA inserts for the
  significant noise reduction.  A rounded earlier opening should help with
  the port open sound bite (Lynn might have numbers).  A rounded later
  closing would help with increased flow at high output and soften the
  apex landing.
  There are lots of exhaust sound reduction tricks, some light and cheap.
  Lynn has posted loads of info in various places.

  BTW, I have an GSL-SE NA car with a Racing Beat exhaust (no pre-silencer
  or inserts), it always sounds like it has a hole in the exhaust.  I need
  to testbed a few sound reduction ideas there too!

  Cheers
  Cary




Cary,

I didn't hear about the DB reduction until I had changed my exhaust inserts
to turbo inserts.  Then someone mentioned that they would cost me about 5db
and wouldn't add any noticable power.  I didn't realize how loud these
engines can be and how difficult it would be to get my engine quiet enough
to live with.  This things overpowers my Lightspeed ANR headset...
amazing.

The thing I don't like about the 20b exhaust splitters is that they have a
passage through them for an EGR (my guess) system which we don't need.  I
will try to close these on my new engine, either through welding them up or
smashing them closed.  I don't want the hot exhaust gasses passing up
through the engine and heating up the side housings.

Mark Steitle

You don't want your engine to turn into a banana either. The exhuast heat is designed to
equalize the temperature between the cold side and the hot side.

IMHO everybody should keep a copy of Yamamoto's book "Rotary Engine" on the nightstand
and read it each night before they go to sleep.

http://foxed.ca/foxed/index.php?page=rx7manual

---------------------------------------------------------------------

More info. You will block off the EGR passages at the exit on the top of the center housing. Turbo engines already have a cast in blockage at this location. This is where the EGR valve normally resides.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.