Subject: oil gallery O-rings and tension bolt seals
From: Rotary Engine
Date: 11/8/2009, 12:18 AM
To: AAA Put this in the To box

OK, that makes more sense.  I'll use 8.93 and 11.21".

Thanks,
Mark

Paul,

I have one question regarding the oil galley o-rings.  I measured those at
.628" ID, .862" OD, and the o-ring cross-section (which had taken a set
 and
was oval-shaped) at .065" - .085" , so that would average out to .075".
Does
this sound correct?  I counted 12 of these, but may order a couple of
extras.

Does McMaster sell the tension bolt seals?

Thanks,
Mark

Here is the Creavey chart. Look at the groove dimensions and the squeeze
and choose the one that works the best. The depth of the slot in the rotor
housings is .070.
The width is 8.62--.628 = .234 / 2 = .117" wide.
The controlling factor would be the squeeze so my guess would be a section
diameter of 0.093. There is plenty of room laterally for it to expand.

If you talk to Jeff ask him if he makes O-rings in metric sizes.
--------------------------------------------------------------

Yes. McMaster Carr key words "Metric sealing washers". Tracy was passing
out plain washers with O-rings and hoping for the best :)

McMaster part number 93786A175 .......85 cents each


Paul Lamar

 It's hard to tell from the McMaster sketch, but the sealing washers appear
 to only have rubber in the hole, not on the underside like the ones Mazda
 uses.  The Mazda washers have a conical sealing area that fit into a
 chamfer
 in the end housing.  So, I have to wonder how they would make a seal
 between
 the bolt hole and underside of the washer.  Maybe adding an o-ring would
 suffice, but I would rather use something closer to the Mazda washer.
 I'll
 take a close look at the ones that came off the engine and see if they're
 good enough to reuse.The price is right though.

 Thanks for the o-ring chart.  I agree that .093" should work.

 Mark S.

 Put a little RTV under them. They seem to work as is as we have used them
 before.
 The tensile load on the tension bolt is so high any minor imperfection on
 the bottom or top surface of the washer, that might cause leaks, would
 probably be crushed. Cast iron is rather soft as well. Sealing washers on
AN
 straight thread fittings work that way.

 Paul Lamar

Yes, that sounds like it will work.  And if one or two do happen to leak, I
can always remove one bolt at a time and fix it without having to tear the
entire engine down.

Mark S.

P.S.  Oven cleaner works great to clean the rotors; just keep it off the
bearings.


There are several sources for seal washers. Google seal-o-stat washers.
Earl's used to sell them. Fastenal carries them too.
Bill Jepson


Thanks for the info Bill.  I'll check into it.

Mark


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.