Subject: turbos as mufflers
From: Rotary Engine
Date: 11/8/2009, 10:55 PM
To: AAA Put this in the To box


Tom

  Your ears must be burning.  Bobby Hughes and I were talking about your
  airplane today.  I was commenting that you were running a RWS gearbox
  behind
  your turbo 20b.  Bobby was asking if you boost for takeoff and climb out
  or
  just for high altitude.  I'm curious as to the longevity of the RWS box
  behind a p-ported 20b.


Mark S.

My 20B is essentially turbo-normalized.  My pop-off valve is set at 32" MP
and my Turbonetics waste gate is limited to 5 psi boost.  So I figure that I
rarely exceed 300 hp into the RWS redrive.  Only time will tell as to its
durability.

My objective was to obtain sea level power at Prescott's 5,000' elevation.
As it turns out, I can hold 32" MP all the way to 17,000'.

I had a problem with my fuel injectors during the return from Oshkosh this
summer.  I suspect that I got some bad mogas in Clay Center, Kansas.
Anyway, I made a precautionary landing in Las Vegas, NM, after the engine
started running a little rough and then skipping an occasional beat. Three
ground runs with injector cleaner finally cleared it up sufficiently for the
2.5 hour flight home.  Two flights later my now smooth running engine began
running extremely rough 15 minutes after takeoff.  Again I suspected plugged
injectors, but four weeks of trouble shooting finally located the culprit in
the injector wiring into the stock Mazda front rotor primary injector.  A
slight pushing or pulling on the wires cut all power to the injector.

So now you know what I've been doing for excitement this summer.  I even
missed giving a forum at CopperState.

Tom P.
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.