Subject: Slide throttle kit cost of housings
From: Rotary Engine
Date: 11/10/2009, 9:12 PM
To: AAA Put this in the To box


I got the kit today, Paul. Looks great. Get 'em while ya can people!

C. Smith


Paul, just saw that these are available. I haven't been following so please
tell me what is required. Do I need to send in housings to PP for the slide
throttle kit?
Sven

You can do the housings yourself or have us do them.

The two are separate.

Read the web site on doing the housings.
http://www.rotaryeng.net/intake.html

If we do them we bore your housings and weld in the SS tubes.
You finish the inside with a die grinder or dremel tool and
seal the water jacket with sealing plates which we bore
when we do the housings.

Boring the housings, welding and fitting the sealing plates
is $150 each.

Paul Lamar
-

 Paul-
    In a recent massage you stated:   "Check the rotor housings width
for shrinkage. You will need a 3 inch
  to 4 inch micrometer.... Shrinkage is a sign of a severely over heated
engine making the rotor housings useless."       What dimensions (and
tolerances) are considered to be a "useable" housing?

    Also, are the "RX8 Style Injector Block, $15 each." (as listed on
your web page) compatible with the 13B 2nd Gen engines? If so, what
type/size injectors would one use on a '91 turbo engine run as a P-ported NA
engine?

    Finally, what size 0.032 Teflon sheet are you recommending we
purchase (separately) for your Throttle Kits?  Lastly, what is the
purpose/function of the "etched" type versus a "non-etched" Teflon sheet?

Thanks!
Paul & Don Vermillion

You will know right away if you follow the measuring procedure in the over haul or shop manual. You can download the manuals from:

http://foxed.ca/foxed/index.php?page=rx7manual

I think tolerance is - .003 as I recall.

The slim RX8 injectors that came out in 2004 were the precursors of the modern injector.
They can be used for the 13B p-port as well as the RX8 P-port. The slimness allows two of them to be mounted side by side on a two inch diameter tube.

What you need is two sheets of 3.5 inches wide by 13 inches long by .032 inches thick Teflon. Etched on one side if you plan on bonding it but I recommend not bonding it as it will be held in place by the bolts. If that proves problematic over time it can then be bonded.

McMaster Carr or Scientific Commodities.
http://www.scicominc.com/

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.