Looks like everything is coming together all at once.
The rest of the slide throttle parts came in for the kit.
The .032" thick Teflon is not included but it cost about $28 for the sheet shown. You
get an extra piece for a spare.
It is easily cut with an exacto knife.
Tom did a great job on the spacer and the slide.
Bolt the two covers over the Teflon when you drill it as Teflon is not easy to drill.
The pre punched covers will hold it in place. No need to bond it to the covers. This
means it is replaceable. The cover bolts and slide keep it in place.
Not included in the the kit is the nuts and bolts or the runner tubes. You can buy those
from Burns Stainless.
This is the way they come. They are not cut to the proper length yet. They will be
shorter of course. The blue hose should be about 2 inches long. 2.5" is shown here.
The price of the slide throttle kit is $175 cash plus $15 cash for shipping. Cheaper
than most throttle bodies the needed size.
Send cash only to:
833 Santa Maria St.
Suite 303
Santa Paula CA
93060
Mazda would have a great open wheel racing series with 300 HP P-port RX8 engines like
this :)
Paul Lamar
--
Paul
I had a question about the Teflon... Above I see we decided to use .032 Teflon and
sandwich an aluminum slide between the two Teflon sheets... The original plan was to
build the slide out of Teflon. What was the reason for the design change... Any benefit
to building the slide out of Teflon verses the sandwich technique? Reason I ask is
because I had already purchased the Teflon for the slide ;-)
Mike C.
Sorry Mike. Put it on ebay. It was mainly a cost issue. We started way back with 3/16
inch and that was not strong enough. Finally we made it 3/8th of an inch thick but the
cost got out of hand as you probably found out. We still had to install a steel button
in there to distribute the load of the throttle cable.
The 1/4 inch aluminum slide allowed us to drill and tap the slide directly for the 10-32
throttle cable and that saved over an inch of length as that was an issue in some
airplanes. The end of the slide was getting too close to the fire wall. That of course
also cut the cost of the teflon.
Paul Lamar
My experience: I got a 5mm bradpoint drill, clamped the rough cut teflon in between the
throttle plates. Drill bolt holes with Brad point, does nice job without causing split
in teflon. Installed 6 teflon buttons on sides of slide. Assebled throttle with bolts,
mark ID of ports on teflon. Trim teflon to perimiter of plates with razor
blade. Dissassemble, use 2" gasket punch for ports in teflon.
C. Smith
I agree. Brad points are the hot tip for Teflon.
Good work Craig. Take some pictures.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.