Subject: We are going to flood the skies with p-ports.
From: Rotary Engine
Date: 11/11/2009, 4:50 AM
To: AAA Put this in the To box



This is not all of them. There are four more.

We have done a couple of junk rotor housing so far to tune the process.

The biggest limit on how fast you can drill a 2 inch hole in a rotor housing is the
rigidity of the mounting fixture and the power and rigidity of the mill. Compared to a
Cincinnati or Kasuga a Bridgeport is a wimp. There is NO substitute for tons of cast
iron and lots of HP :)

http://www.youtube.com/watch?v=7odN-h7rsGQ

We now have two angle plates bolted together with  four pieces of 5/8th inch diameter
threaded rod and eight 1/2 inch hold down T bolts on the Bridgeport mill. I wish my
Kasuga were running.

-----------------------------------------------------------------------

One of the other things we tried was an experiment with the weld on a junk housing.
We recessed the tube 1/32nd into the bore resulting in a much lower profile weld so you won't have to do much die grinding to clean up the transition. The weld bead  is almost flush with the rotor housing wear surface. It never ceases to amaze me how well these welded p-ports work. IMHO it is the only way to go.

On the other hand you will need a special long tap so the tap handle will clear the SS tube. The tube protrudes about 1.5 inches at the top. This needs to be done to clamp the sealing blocks to the rotor housings. I recommend a Greenfield EM-AL-GUN-TAP 1/4-20 Rutland Tool & Supply part number 7116 4207  Cost is $12.73. This tap is 3.15 inches over all length. Drill the top left tap hole about one inch deep. That is the only blind hole. The other three are through holes into  the water jacket.

Take your time and don't screw this up as a repair with a helicoil set could be real difficult.

We have done the hard part. It is up to you to do a bit of time consuming finishing work. I can't promise when we will ship as the blocks are in the NC shop for the O-ring groove. I think I will order the right O-rings for you and install them in the blocks.


Here is another idea. Instead of using uncured red RTV silicone rubber one can buy cured RTV in films to use as a conformal gasket. Good to 500 F.

http://www.mcmaster.com/#rubber-sheets/=4geun0


Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.