Subject: We are going to flood the skies with p-ports.
From: Rotary Engine
Date: 11/11/2009, 9:04 AM
To: AAA Put this in the To box



This is not all of them. There are four more.

We have done a couple of junk rotor housing so far to tune the process.

The biggest limit on how fast you can drill a 2 inch hole in a rotor housing is the rigidity of the mounting fixture and the power and rigidity of the mill. Compared to a Cincinnati or Kasuga a Bridgeport is a wimp. There is NO substitute for tons of cast iron and lots of HP :)

http://www.youtube.com/watch?v=7odN-h7rsGQ

We now have two angle plates bolted together with  four pieces of 5/8th inch diameter threaded rod and eight 1/2 inch hold down T bolts on the Bridgeport mill. I wish my Kasuga were running.

Paul Lamar


Paul
 Did you get the sealing plates I sent back? Is the plan to cut the 2" hole with the plates attached?

Mike C.


Yes I got them and they went into the NC shop for O-ring grooves.

We now put them on after welding.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.