Subject: We are going to flood the skies with p-ports.
From: Rotary Engine
Date: 11/11/2009, 6:06 PM
To: AAA Put this in the To box



 This is not all of them. There are four more.

 We have done a couple of junk rotor housing so far to tune the process.

 The biggest limit on how fast you can drill a 2 inch hole in a rotor
 housing is the
 rigidity of the mounting fixture and the power and rigidity of the
 mill. Compared to a
 Cincinnati or Kasuga a Bridgeport is a wimp. There is NO substitute
 for tons of cast
 iron and lots of HP :)

 http://www.youtube.com/watch?v=7odN-h7rsGQ

 We now have two angle plates bolted together with  four pieces of
 5/8th inch diameter
 threaded rod and eight 1/2 inch hold down T bolts on the Bridgeport
 mill. I wish my
 Kasuga were running.

 -----------------------------------------------------------------------

 One of the other things we tried was an experiment with the weld on a
 junk housing.
 We recessed the tube 1/32nd into the bore resulting in a much lower
 profile weld so you
 won't have to do much die grinding to clean up the transition. The
 weld bead  is almost
 flush with the rotor housing wear surface. It never ceases to amaze me
 how well these
 welded p-ports work. IMHO it is the only way to go.

 On the other hand you will need a special long tap so the tap handle
 will clear the SS
 tube. The tube protrudes about 1.5 inches at the top. This needs to be
 done to clamp the
 sealing blocks to the rotor housings. I recommend a Greenfield
 EM-AL-GUN-TAP 1/4-20
 Rutland Tool & Supply part number 7116 4207  Cost is $12.73. This tap
 is 3.15 inches
 over all length. Drill the top left tap hole about one inch deep. That
 is the only blind
 hole. The other three are through holes into  the water jacket.

 Take your time and don't screw this up as a repair with a helicoil set
 could be real
 difficult.

 We have done the hard part. It is up to you to do a bit of time
 consuming finishing
 work. I can't promise when we will ship as the blocks are in the NC
 shop for the O-ring
 groove. I think I will order the right O-rings for you and install
 them in the blocks.


 Here is another idea. Instead of using uncured red RTV silicone rubber
 one can buy cured
 RTV in films to use as a conformal gasket. Good to 500 F.

 http://www.mcmaster.com/#rubber-sheets/=4geun0


 Paul Lamar


 Paul,
 what filler rod is he using when he welds the housing?
 Thanks,
 Larry

I don't know.  I don't think it needs much. There is no load on them so weld strength is
not an issue. A good weld without porosity is more important for pin hole leak problems.

I'll ask him what he is using.

--------------------------------------------------------------------

Here is what the set up looks like.

Don't be fooled by the sealing blocks. One person sent us the rotor housing with the sealing blocks already installed and teh cavity potted with JB Weld. We left them on there as an experiment when we bored the housings. We will replace them with the new sealing blocks with the O-ring in them.

The blocks are finished and waiting for me to pick up in the NC shop.

Paul Lamar



-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.