Subject: Slide throttle: Needed with carb?
From: Rotary Engine
Date: 11/12/2009, 2:37 AM
To: AAA Put this in the To box


I'm fairly sure I'm going to eventually go with a simple mechanical carb with manual
leaning (as we discussed a while back).  If so, what's the likely penalty
(HP/weight/fuel consumption) for using the built-in throttle on the carb rather than
going with the more efficient slide throttle for a NA 13b P-Port setup?
Thanks

Mark W.
                        

I don't know Mark but my guess is not much.  The big problem with a 13B p-port and carb
is idling stability. You need the throttle close to the rotor housing. With an RX8 side
exhaust it would be just as  stable as a side intake 13B.

---------------------------------------------------------------------

Another problem you will have to deal with is stand off fuel vapor. With any tunned system air flows both in and out of the carb. At around peak torque plus or minus 1000 RPM lots of fuel vapor is generated outside the carb as the air flowing out of the carb also sucks fuel out of the venturi. You can see this in our Youtube video Using a weber carb.

http://www.youtube.com/watch?v=LkKw72dZ2yc
http://www.youtube.com/watch?v=KQL45DYgIFw

We checked for this with fuel injection on Marks Suspinski's engine and it does not happen.

You will have to deal with this fuel vapor with a sealed air box above the carb to make sure all the fuel vapor is captured. I am not sure how much of this happens if the air box is provided with ram air at cruising speed. I suspect the phenomena is much reduced.
Sorry but you will be on the cutting (bleeding?) edge.

Here are some 3D's of a system using a Holley 500 CFM two barrel carb with leaning block.

Paul Lamar


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.